\addcontentsline between other commands, not in the middle of one. Look for a place in the macro after the new page/chapter has started,īefore the actual listing begins. Too early and you get the "page before" problem, too late and If you know some latex you'll see a good spot. You should almost always insert a figure float first, then put a figure inside that. 'Figure float' is more what one means by a figure in a paper: it includes the graphic, the caption, the figure label, etc. 'Figure' is what I would really call a 'graphic' it basically means insert a picture file. \newpsstyle somewhere in the middle of it. This is an example of less-than-ideal terminology. In Microsoft Word, you can insert a cross-reference to content in another part of your Word document and then update it if the target of the cross-reference changes. As pst-gantt loads pstricks package you can only export/view your document to PostScript, DVI or PDF(ps2pdf).įor example adding this TeX Code in your document you can to make a simple Gantt chart: This can be accomplished by using the labels sec:population for the section, tab:population for the table, and fig:population for the figure. As well pst-gantt loads by default the following packages: pst-node, pst-grad, xkeyval and pstricks, so all them should be already part of your local TEX installation. a figure containing a bar chart of the population sizes, it might be convenient to refer to all of them using variants of population. If you want to create a Gantt chart in Lyx you need LaTeX-package pst-gantt ( (approve sites)) in your preamble document.
0 Comments
Leave a Reply. |